Documents publiés en "2009"

E

Erkan, T., Mayer, J. R. R., & Dupont, Y. (octobre 2009). Compensation for the unknown geometry of a reconfigurable uncalibrated 3D ball artefact for fiveaxis machine volumetric check [Communication écrite]. 24th Annual Meeting of the American Society for Precision Engineering (ASPE 2009), Monterey, CA, United states. Non disponible

N

Nafi, A., Mayer, J. R. R., & Wozniak, A. (octobre 2009). Redundancy method for the separation of machine and triggering probe errors in small volume measurement on a CMM [Communication écrite]. 24th Annual Meeting of the American Society for Precision Engineering (ASPE 2009), Monterey, CA, United states. Non disponible

O

Onat Ekinci, T., Mayer, J. R. R., & Cloutier, G. (2009). Investigation of accuracy of aerostatic guideways. International Journal of Machine Tools and Manufacture, 49(6), 478-487. Lien externe

S

Slamani, M., Mayer, J. R. R., Balazinski, M., & Engin, S. (mai 2009). Modeling and prediction of machines tools errors from circular tests [Communication écrite]. CANCAM 2009, Halifax. Non disponible

W

Wozniak, A., & Mayer, J. R. R. (octobre 2009). Corrected measured point validity check in coordinate metrology [Communication écrite]. 24th Annual Meeting of the American Society for Precision Engineering (ASPE 2009), Monterey, CA, United states. Non disponible

Wozniak, A., Mayer, J. R. R., & Balazinski, M. (2009). Stylus tip envelop method: Corrected measured point determination in high definition coordinate metrology. International Journal of Advanced Manufacturing Technology, 42(5-6), 505-514. Lien externe

Z

Zargarbashi, S. H. H., & Mayer, J. R. R. (2009). Single setup estimation of a five-axis machine tool eight link errors by programmed end point constraint and on the fly measurement with Capball sensor. International Journal of Machine Tools and Manufacture, 49(10), 759-766. Lien externe